Category Archives: News

Posted on December 15, 2009 by admin • 0 Comments

The U.S. Air Force awarded SFTC an SBIR project on Integrated Processing and Probabilistic Lifing Models for Superalloy Turbine Disks. Continue Reading

Posted on September 22, 2009 by admin • 0 Comments

DEFORM_News_Fall_2009: A 64-bit FEM engine is currently being introduced for DEFORM-3D. Continue Reading

Posted on June 21, 2009 by admin • 0 Comments

DEFORM_News_Summer_2009: The use of DEFORM in the development of new patent pending tilt rolling and sputtering processes is the topic of this issue. Continue Reading

Posted on March 20, 2009 by admin • 0 Comments

DEFORM_News_Spring_2009: A ring rolling code was summarized in DEFORM News last Spring. Since that edition, a number of applications have been developed and published. Extensive code testing has been performed,… Continue Reading

Posted on December 21, 2008 by admin • 0 Comments

DEFORM_News_Winter_2009: Decoupled die stress analysis is a very popular tool to increase die life and understand the root cause of failures. In this issue, setup tips are provided from a… Continue Reading

Posted on October 1, 2008 by admin • 0 Comments

SFTC has been awarded an SBIR project by the U.S. Air Force on Modeling Spin Testing using location specific material properties. Continue Reading

Posted on September 22, 2008 by admin • 0 Comments

DEFORM News Fall 2008: Coupled die stress analysis is required from time to time to detect mid-stroke tooling failures. A case of a piston punch is described in this issue. … Continue Reading

Posted on June 20, 2008 by admin • 0 Comments

DEFORM-News-Summer-2008: White layer in machining is discussed. This is a very sophisticated application of microstructure analysis to a machining simulation. The results matched experimental data with excellent correlation. Continue Reading

Posted on May 13, 2008 by admin • 0 Comments

SFTC has been awarded an SBIR and STTR project by the U.S. Air Force and U.S. Navy to continue microstructure development for aluminum and nickel alloys. Continue Reading

Posted on March 20, 2008 by admin • 0 Comments

DEFORM-News-Spring-2008: After years of development, a practical ring rolling simulation capability is available in DEFORM. A summary of the current capabilities is the focus of this issue. Continue Reading

– 2545 Farmers Drive – Suite 200 – Columbus, Ohio 43235 – Tel: (614) 451-8330 –Copyright © Scientific Forming Technologies Corporation | SitemapDEFORM® is a registered trademark of Scientific Forming… Continue Reading